SFML VS13 Entry Point Not Found

[dleanjeanz]

Of course I was just configured it so (ADDED:as to get the output at the bottom of cmake after configuring.) I didn't press Generate 'cause I've been trying generating and opening the solution again and again

And the IDE didn't say anything when I open the solution. In the Solution Explorer showed as in the picture I uploaded before in this topic and some misc. things generated by cmake (INSTALL, ZERO_CHECK, ALL_BUILD)

If you can't the solve the problem, I'll be OK using the dynamic librabries

[eXpl0it3r]

Of course I was just configured it so I didn't press Generate 'cause I've been trying generating and opening the solution again and again

Not sure if that was lost in translation, but if you didn't press generate, you have to!
Pressing configure will only change internal CMake state, generate creates the new project file.