Messages

1

General / Re: SFML Project DLL entrypoint failure

« on: January 13, 2020, 08:38:56 pm »

So I have to make a new project from scratch if I use CMake?

Is there another way which preserves my project?

2

General / Re: SFML Project DLL entrypoint failure

« on: January 11, 2020, 10:59:22 pm »

How do I do this in Code::Blocks?

I can't find anything about rebuilding it.

I also wouldn't be opposed to making changes to make it work in earlier versions of C++. Last time I did anything before this was in Visual Studio 2005, so I doubt I'm using many new features.

3

General / SFML Project DLL entrypoint failure

« on: January 11, 2020, 08:28:04 am »

Hello, I registered here after searching for a while to find the answer to this, but it doesn't seem many people have the same problem. Lucky them!

I'm writing a game in Code::Blocks using the latest version of both Code::Blocks and of SFML at the time of writing. I followed the tutorial and documentation, and when compiled and run from CB the program works flawlessly. Everything operates smoothly and properly as intended.

But... I can't get the EXE files to work. I know SFML must be installed correctly for everything to be working this well. Placing the EXE in a new folder with all DLL files and the few external resources it currently uses, it will not start.
Attempting to launch the file, it gives me a procedure entry point error for system, graphics, and window before closing.

I am on Windows 10, I have an Intel HD4000 video card (this is a laptop), I'm using the dynamic libraries if it wasn't clear, I am not using a snapshot version, and none of the relevant code seems to be an issue. As I said, it works fine in the IDE.

Any help is appreciated. Hope I did a good job with my first post.

Pictured below are some cropped screenshots I took to aide in understanding the problem. The first three are the errors I am getting, the fourth is the directory of the folder, and the fifth shows it running in Code::Blocks.